Harry Potter String Art

Have you seen those string art images of your home state or a heart plastered all over Pinterest? Have you seen any that are the least bit geeky? I haven’t. I had never made one of these before now but I wanted to represent my favorite fandom by making the symbol of the Deathly Hallows.

SuppliesSupplies:

Board big enough for your image

Printed image

Scissors/Craft knife

Hammer

Nails–make sure your nail has a good lip on the head. Mine didn’t have much of a lip and it caused some problems when I was putting the string on

String in the color(s) of your choice

HP String art image Once you have your image cut out, position it on your board. I used some washi tape to hold the image down. I went with washi tape because (1) it was on hand and (2) it doesn’t pull up the paint/stain on the board.

Start pounding in nails! This felt like it took forever. I had to spread it out over a few days because it made my tennis elbow kick in big time. I also had to use pliers to hold the nails because they were too small for me to hold with my fingers.HP String art nailsYou can see in the picture above that I’m almost done pounding in the nails! Yay! It was easy to tell if a nail wasn’t pounded in well because it would pop out while hammering in another nail.

Once you have all your nails in, and there aren’t any loose nails, remove your image.

HP string art no stringIt’s time to start winding your string around the nails. I used a slip knot to start my string out. You’ll notice that I used a heavier string (as opposed to thread) and that it had variegated colors.

The Puzzling Crafter: HP string artThis was a bit frustrating. As I mentioned earlier, my nails didn’t have a large enough lip on the head to keep the string from slipping off.

Finally done!

HP String Art finished

I added a quote to the bottom by transferring printed words onto the wood. I tested this out on the back of the board a few times to get it down. I’m no expert on wood transfers, and you may notice the error I made.

Wood Transfer ErrorCheck out the word “enemy”. Yup, I had a spelling error that I didn’t catch during all my trials on the back of the board. I had it as “emeny” but was at least able to wipe away half of the “m” so that it wasn’t quite as bad of an error. There wasn’t anything I could do to fix the rest of the word. Oh well, lesson learned.

I would love to see what you make! Let me know in the comments how it goes for you or if you have any tips to add!

Don’t forget to subscribe so you don’t miss out!

 

3 thoughts on “Harry Potter String Art”

  1. I liked it a lot. It’s nice to see that you were humble enough to show your spelling error. Sometimes we think bloggers as perfect people who don’t mess it up while the rest of the world can’t get it done at all hahaha. Abra├žos from Brazil.

    1. I’m glad you enjoyed this post. I have always considered myself a terrible speller and so I usually double check all of my work. But like you say, people aren’t perfect! What a boring world this would be if we could all edit away our mistakes before the rest of the world noticed. Thanks for your comments!

Leave a Reply

Your email address will not be published. Required fields are marked *